There’s even a zero ohm SMT resistor that could be repositioned slightly to feed RF to the UHF jack. A little work with a soldering iron and [Brian]’s Pi was connected to an external antenna.

For best results, the cable must be directly soldered to the PCB. The circuit should be installed near the antenna and housed in a water proofed case. The power supply for this uhf tv antenna ...

The UHF band is more directional than VHF and more sensitive to obstacles (such as trees, tall buildings, and mountains) that lie between your antenna and the broadcast tower. So getting good UHF ...

You would construct a counterpoise antenna wire 11.5 inch for VHF, 6.5 for UHF and about 19.5 inches for an OK performing dual band VHF/UHF radio. Normally with a handheld radio the counterpoise ...

In TechHive tests the antenna scored better than any others in its class. The Elite 7550 is suitable for both VHF-High and UHF broadcasting bands, which covers the vast majority of TV stations in ...

If your analog signal was at a certain frequency range, such as in the VHF band, and digital one that replaces it is in the UHF band, then you may need to replace your antenna." "But that's simply ...

For this UHF antenna tv amplifier to work correctly you need to cut the components pins as short as possible. C1, C2, C6, C7 are SMD type ( surface mounted ). This antenna tv amplifier or uhf wideband ...