There are many circuits for low voltage regulators. For higher voltages, such as supplies for valve circuits, the situation is different. That’s why we decided to design this simple regulator that can ...

Now that autos are moving toward high-powered battery voltage, the industry is turning new attention toward making sure the flow can stop on a dime when needed. Power management company Eaton Corp.

This simple circuit adds short-circuit load protection to a basic driver such as the output of a simple logic gate, while allowing it to control a high-power load operating at a much-higher voltage ...

This voltage regulator delivers smooth control of a constant voltage from 0 to 8 V. It protects the load against short circuits and indicates connection, overload, and output level. The series chain ...

If a motor isn't adequately protected, a short circuit will likely result in premature replacement. Then there's the problem of nuisance tripping upon initial start-up because the magnetic setting of ...

Dual parallel expansion: Two WSP4407s in parallel can support 16A, suitable for rear long seats with 200W high power, with a temperature rise of <35°C, without the need for additional heat sinks.

Q. What is the Code rule for sizing short circuit and ground fault protection for a motor feeder? A. Feeder conductors must be protected against short circuits and ground faults by a protective device ...

According to the company, when combined with Breaktor circuit protection technology, which combines current switching and reconfigurable bi-directional short circuit protection with fast tripping, ...

SMPS is the abbreviation of switching mode power supply, a kind of high-frequency power conversion device and a power supply device. Its function is to convert a level of voltage to the voltage or ...

WASHINGTON, D. C. - President Joe Biden and Vice President Kamala Harris are launching a new, government-wide initiative on Monday to crack down on hurdles that waste consumers’ time and money, like ...

A guaranteed way to make a receiver or amplifier fail is to create a short circuit by improperly connecting speaker wire to your speakers or receiver. It could be as simple as a stray strand of wire ...