A buck converter is a DC-DC power device that efficiently steps down a voltage to a lower level. It uses an inductor, ...

You use one resistor to programthe IC, which delivers 0 to15V at currents as high as 1.5A.It includes an internal 50-μA referencecurrent to establish theoutput voltage, which you can adjust ...

The TS3001's timer frequency is set with just one resistor while theTS3002 is set with a resistor and a capacitor. Frequency out period drift is avery low 0.021%/°C for the TS3001, compared with the ...

As explained by Arduino to Go, each color band on the resistor corresponds to a number but this can differ depending on the band's placement. It's not complicated, but the sheer number of colors ...

As part of the back end of IC manufacturing, trimming is accomplished by burning away part of the resistor structure using a laser beam. As the resistor's effective cross-section is reduced ...

The IC is designed for single-supply operation from 10.8 V to 13.2 V and has 1.5 m? internal conductor resistance. It is protected against electrostatic discharge at up to 2 kV for all pins.

The Toshiba TC78H670FTG two-phase, bipolar, stepper-motor driver removes the need for any external current-sense resistor by incorporating on-chip current detection.

Power Integrations has designed an IC that disconnects sense resistors from high-voltage rails during standby or remote-off conditions. The SENZero range of devices is designed to eliminate sense ...